Datum dimensions
Which dimensions establish mounting distance, shaft location and the relationship to the tooth geometry?
Manufacturing & quality
Manufacturing & Quality for Spiral Bevel Gears
The manufacturing route is planned around the controlled drawing and the acceptance method. The aim is to keep blank datums, heat-treatment condition, tooth finishing and final inspection connected rather than treating them as isolated operations.
Process route
1
Drawing & datum review
Confirm the gear pair, machining references, interfaces and inspection requirements.
2
Blank & machining preparation
Plan turning and interface machining so later gear operations have stable references.
3
Gear cutting & heat treatment
Use the ordered gear system and protect critical surfaces according to the process plan.
4
Finishing & inspection
Finish teeth where specified, verify drawing characteristics and prepare agreed records.
Inspection scope should be agreed before production
Not every part needs the same report. A replacement pair may depend on contact, mounting geometry and dimensional comparison with a sample. A drawing-controlled production part may call for a defined gear quality standard, runout, bore or spline checks and material/heat-treatment records. Put these expectations into the RFQ so they can be included in the route and quotation.
Typical inspection questions
Pair identification
Are the mating components controlled as a set, and how must hand or pair marking be managed?
Gear quality
Which gear-quality or tooth inspection requirement applies to the ordered configuration?
Material condition
Which material, heat-treatment and hardness requirements are stated on the controlled drawing?
見積もりを依頼する
見積依頼書を送信するギアペア、図面、および仕様を1つの見積依頼書にまとめて送付してください。
接合関係と組立基準が明確に定義されていればいるほど、構成の確認は迅速に行える。
注文と配送に関するご案内
最小発注数量（MOQ）は、製品の種類、製造方法、および注文総額によって柔軟に対応可能です。適切な新規プロジェクトでは、サンプル価格で1～5個のサンプルを注文できます。注文総額が約1,500米ドルに達した場合、複数のモデルを組み合わせることができます。1～2個の注文も検討可能ですが、通常は単価が高くなります。
標準部品の一般的な納期は10～25営業日、特注部品は20～45営業日、プロジェクト型機器または組立品は45～120営業日です。EXW、FOB、CIF、DAPは一般的に対応可能ですが、FCA、CFR、CPT、CIP、DDPについてはご相談ください。
